This package is a complete solution that allows fast development and configuration of interlocks, a task that normally takes a lot of time. This works with 32 inputs and comes with four faceplate's sizes suitable for all types of HMI and SCADA systems.

This function integrates anything you may need. Just set the parameters and you will have the output ready to use.

Integer Value Move to BIT status (Version Studio5000 V32.02)

The module provides an alarm bypass function for Analog and discrete inputs.

The Add On Instruction is used for the control of an Industrial Safety Gate (Euchner MGB series).

IC_MOV_2P Add On Instruction can be used for the control of 02-Poisition (Open/) motorized valve. In addition to the full control of motorized valve , this instruction generates Failure Alarms to enable device diagnostics and allow plant operators to perform maintenance if the valve is jammed or locked.

This module sets an alarm when the measured value exceeds the High Level setpoint for longer than the Time value.

This module converts a timer value (DINT) to a string value for display on an HMI.

When the module is enabled the state of the 16 discrete inputs is copied to the outputs.

This module copies the state of the inputs to the outputs when enabled. Default state is off.

The module stores a set of values (e.g. measurement) and provides their maximum, minimum and average values .

This module converts an analog value to its exponent (i.e exp + mantissa).

Works exactly like a for do loop in higher programming language but used in ladder logic

Used for First Out tripping and alarming. Inputs are set are set high to cause trip/alarm.

Flow Rate Conversion (Volume)

Flow Rate Conversion (Mass)

Use this control module to control output as on/off flashing output. An example may be 1s on, 2s Off flashlight. it also can be used for flashing a bit in HMI with set time durations.

Flashes an output based on user specified time values.

This module monitors the status of 16 discrete inputs and sets the Alarm Channel No to the value of the input channel that first goes into alarm.

This module captures the first channel that goes into alarm.

This module monitors the state of the FCV and provides alarms based on the status read by the open and close limit switches.