The module provides voting logic for 2 out of 3 inputs.
The module is used to control a motor in Manual or Automatic mode.
The module is used with Plant PAx motor modules to limit the motor start/stop and reverse functions.
The module is used to control a fixed speed motor with all alarms and faults interlock.
This module monitors the state of the FCV and provides alarms based on the status read by the open and close limit switches.
The module is used to control an Electric Heater in Manual or Automatic mode.
The module reverses an ASCII string.
This module monitors the status of 16 discrete inputs and sets the Alarm Channel No to the value of the input channel that first goes into alarm.
The module scales the raw input to the Engineering Range and creates High High, High, Low and Low Low alarms.
This module captures the first channel that goes into alarm.
This module sets an alarm when the measured value falls below the Low Level setpoint for longer than the Time value.
This module sets an alarm when the measured value exceeds the High Level setpoint for longer than the Time value.
The program is designed to govern any sequential order of tasks done by outputs with basic feedback from inputs.
Analog Raw Value from Sensors Scaling to real Value
Counting operating hour
AOI for 2 in 1 Out Linear Cylinder Control and fault report.