This module provide control for an on-off valve.

This module provides comprehensive control function for a Direct On Line motor.

This module provide analog scaling and alarming for an input with an raw value of 0-27648 (4-20 ma).

AOI with SE Faceplate for Pump or Motor start stop

When your Digital input has an OK state and Alarm state, you need to process it before you shall use it. For example, Safety System, Lift Door, Emergency Switch, an application where input states false or low shall give an alarm.

Use this control module to control output as on/off flashing output. An example may be 1s on, 2s Off flashlight. it also can be used for flashing a bit in HMI with set time durations.

The module provide control for an Digital Valve (Open/Close) as well as n HMI faceplate.

This module monitors the status of a PowerFlex 40 Drive.

This block limits an input depending on the configured high and low values and transfer the value to the output depending on the limits.

This block selects between the first or the second group of real variables.

This block is a multiplexer function. When a single input is on, the corresponding single output real value will be on.

On/Off valve with a single output and both opened and closed. It also can be used without feedback - in that case ignore fail to open/close variable at the output. feedback. Applies to all pneumatic on/off valves with both opened and closed position feedback.

Scantime function that can return scantime cycle in microseconds, milliseconds and/or seconds.

Ramp block that generates a ramp using acceleration and deceleration values defined by user.

The module populates the status of bits into a integer.

The module is used to create the runtime value for a condition.

The module provide Lead Lag control for 2 motors.

The module provides control of a pump (or motor).

This module allows recipes to be slected and stored in a PLC. An HMI application is included for FactoryTalk ME.

Ramp Function Generator

Module for control of two-position actuator with feedback