IC_MOV_2P Add On Instruction can be used for the control of 02-Poisition (Open/) motorized valve. In addition to the full control of motorized valve , this instruction generates Failure Alarms to enable device diagnostics and allow plant operators to perform maintenance if the valve is jammed or locked.

Integer Value Move to BIT status (Version Studio5000 V32.02)

The instruction uses to toggle the signal

The module populates the status of bits into a integer.

This module sets an alarm when the measured value falls below the Low Level setpoint for longer than the Time value.

This module sets an alarm when the measured value exceeds the High Level setpoint for longer than the Time value.

Counting operating hour

SCALE_AI Add on instruction converts raw value from Analog Input channel to engineering value and in addition presents several alarms based on user configuration, including Hi, HiHi, Lo and LoLo Alarms.

8 input REAL value, find minimum. maximun and average. Except 0 if input value = 0, it won't be counted in sum and average

Elapse/Remaining Timers accumulated values conversion in clock format .

When your Digital input has an OK state and Alarm state, you need to process it before you shall use it. For example, Safety System, Lift Door, Emergency Switch, an application where input states false or low shall give an alarm.

Use this control module to control output as on/off flashing output. An example may be 1s on, 2s Off flashlight. it also can be used for flashing a bit in HMI with set time durations.

Scantime function that can return scantime cycle in microseconds, milliseconds and/or seconds.

This piece of code is provided as a ladder coded Routine.

Converts Milliseconds to Hours / Min / Seconds.

This module generates a random number (data type: Real) between 0 and 1.