The module is used to control an Electric Heater in Manual or Automatic mode.

The module reverses an ASCII string.

This module monitors the status of 16 discrete inputs and sets the Alarm Channel No to the value of the input channel that first goes into alarm.

The module scales the raw input to the Engineering Range and creates High High, High, Low and Low Low alarms.

This module captures the first channel that goes into alarm.

The program is designed to govern any sequential order of tasks done by outputs with basic feedback from inputs.

AOI for 2 in 1 Out Linear Cylinder Control and fault report.

AOI for 1 in 2 out Linear Cylinder Control and fault report.

AOI for 2 in 2 out Linear Cylinder Control and fault report.

This module copies the state of the inputs to the outputs when enabled. Default state is off.

The module selects the high, low or average value of 5 analog inputs.

Flow Rate Conversion (Mass)