Flow Rate Conversion (Volume)

Temperature Conversion

Used to replace standard faceplate in PlantPAX 2.0

Used to replace standard faceplate in PlantPAX 2.0

Used to replace standard faceplate in PlantPAX 2.0

When the module is enabled the state of the 16 discrete inputs is copied to the outputs.

Used for latch an output OFF when the corresponding input to the module goes OFF.

Used for latch an output ON when the corresponding input to the module goes ON.

Used for First Out tripping and alarming. Inputs are set are set high to cause trip/alarm.

The BNOT16 block allows up to 16 Boolean conditions to be inverted. By using the BNOT16 block in application code the required inversion of signals is clearly shown within the Function Block Diagram (FBD).

Double Solenoid 2 position operation

This module is for Mitsubishi Fx3U and is built on GX works tools in function block diagram This totalizer will totalize the flow rate. The totalizer will auto reset at user's defined value as well user controlled reset is also given.

Digital Output Control Module Note: Programmed followed ISA88, ISA95, and ISA106 Standard

Count the operating time of equipment

The AOI provides a sensor signal to be treated according to its authenticity proof. The AOI is mainly developed to be used with any industrial protocol sensor/gateway/module (ex. Modbus sensor/gateway, remote IO etc), but could be used with any analog measured value.

This block selects between the first or the second group of real variables.