This add-on instruction counts the number of HIGH bit/s in an integer (INT) or double integer (DINT). Counter that counts anything that can become active at the same time and recounts if anything changes.

Determines if a value stays within a % range for an amount of time and returns TRUE when it does. Useful for applications in weighting quantities

The Digital Input AOI Control Module is used for general-purpose discrete inputs. Note: Programmed followed ISA88, ISA95, and ISA106 Standard

Module for control motor in 2 directions

Takes the input from the analog card.Outputs a scaled value and HH/HI/LO/LL alarms. Can be imported as a library and it will create all the variables automatically or can be imported as a AOI.

This block limits an input depending on the configured high and low values and transfer the value to the output depending on the limits.

Ramp block that generates a ramp using acceleration and deceleration values defined by user.

A variable input that you want a non-linear varied output.

IC_MOV_2P Add On Instruction can be used for the control of 02-Poisition (Open/) motorized valve. In addition to the full control of motorized valve , this instruction generates Failure Alarms to enable device diagnostics and allow plant operators to perform maintenance if the valve is jammed or locked.

Integer Value Move to BIT status (Version Studio5000 V32.02)

The instruction uses to toggle the signal

The module populates the status of bits into a integer.