When the module is enabled the state of the 16 discrete inputs is copied to the outputs.
Used to replace standard faceplate in PlantPAX 2.0
Temperature Conversion
Flow Rate Conversion (Volume)
Flow Rate Conversion (Mass)
The module selects the high, low or average value of 5 analog inputs.
This module copies the state of the inputs to the outputs when enabled. Default state is off.
AOI for 2 in 2 out Linear Cylinder Control and fault report.
AOI for 1 in 2 out Linear Cylinder Control and fault report.
AOI for 2 in 1 Out Linear Cylinder Control and fault report.
The program is designed to govern any sequential order of tasks done by outputs with basic feedback from inputs.
This module captures the first channel that goes into alarm.
The module scales the raw input to the Engineering Range and creates High High, High, Low and Low Low alarms.
This module monitors the status of 16 discrete inputs and sets the Alarm Channel No to the value of the input channel that first goes into alarm.
The module reverses an ASCII string.
The module is used to control an Electric Heater in Manual or Automatic mode.
This module monitors the state of the FCV and provides alarms based on the status read by the open and close limit switches.
The module is used to control a fixed speed motor with all alarms and faults interlock.
The module is used with Plant PAx motor modules to limit the motor start/stop and reverse functions.
